WaveShare E-Ink Display Hat

£18.00

WaveShare E-Ink Display Hat for Raspberry Pi 4B/3B+/3B/Zero.

This is an E-Ink display HAT for Raspberry Pi, 2.13inch, 250×122 resolution, with an embedded controller, communicating via SPI interface, supports partial refresh.
Due to the advantages like ultra-low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.

Subtotal:

Add-ons total:

Total:

Feature :

No backlight keeps displaying last content for a long time even when power down Ultra-low power consumption, basically power is only required for refreshing Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Specifications :

Operating voltage: 3.3V/5V Interface: SPI Outline dimension: 65mm × 30.2mm Display size: 23.71mm × 48.55mm Dot pitch: 0.194 × 0.194 Resolution: 250 × 122 Display color: black, white Grey level: 2 Partial refresh time: 0.3s Full refresh time: 2s Refresh power: 26.4mW(typ.) Standby power: <0.017mW Viewing angle: >170°

Interface :

• VCC: 3.3V / 5V • GND: GND • DIN: SPI communication MOSI pin • CLK: SPI communication SCK pin • CS: SPI chip select pin (active low) • DC: data/command control pin (high level means data, low level means command) • RST: external reset pin (low-level reset) • BUSY: Busy output pin (low level means busy)

Dimensions :

How to Use :

Refer to this link : www.waveshare.com/wiki/2.13inch_e-Paper_HAT

Packing list :

1 x 2.13 inch e-Paper HAT 1 x Screws Set 1 x PH2.0 20cm 8Pin

Reviews

There are no reviews yet.

Be the first to review “WaveShare E-Ink Display Hat”

Your email address will not be published. Required fields are marked *